Michell Engineering Rega 3-Point VTA Adjuster 3

Description

VTA Adjuster 3

The Michell VTA adjuster 3 allows you to easily adjust the
height of your tonearm, so it is perfectly level no matter what cartridge you
choose to use. Correctly setting the vertical tracking angle (VTA) and
subsequently the stylus rake angle (SRA) for your cartridge, allows the stylus
to perfectly track the vinyl groove, optimizing the amount of detail extracted
from the recording.

**Please note** The VTA/SRA adjuster’s base is 2mm thick and
once installed and set to its lowest position, the adjuster will raise your
tonearm by 2mm. If you are using the adjuster with a Michell Engineering Gyro
or Orbe model turntable then please fit the shorter 10mm arm plate spacers
supplied, to compensate for the added height of the adjuster. If you wish to
use the adjuster on a turntable where the arm plate/board cannot be lowered,
then please note that your tonearm will be 2mm higher before any adjustment has
taken place. The VTA/SRA adjuster comes with three nylon washers, these are to
be used if you wish to raise the tonearm more than the 3.5mm of lift available
using the adjuster on its own. 

*Compatible with Rega tonearms using the redesigned three
point fixing base, such as the RB220, RB330

*Currently not compatible with Rega turntables
that utilize ‘Double brace technology’