Audio-Technica AT-MONO3/LP High-Output MC Cartridge for Mono LPs & 45s

No Longer Available

$189.00

Free Lifetime Technical Assistance
SKU: AT-MONO3/LP

Description

The AT-MONO3/LP is a high-output (1.2 mV) moving coil
cartridge designed specifically for use with mono vinyl records.* Due to the
horizontal configuration of its PCOCC (Pure Copper by Ohno Continuous Casting)
voice coils, the AT-MONO3/LP cartridge only generates electrical signal with
horizontal movement, yet it also has appropriate compliance in the vertical
direction, making it safe for use with stereo records. The voice coils are
wired in series, resulting in one mono signal that is transmitted to the
cartridge’s white-blue terminals and red-green terminals in order to feed both
inputs of a stereo phono preamp. 

The cartridge’s low-mass 0.6 mil conical stylus is mounted
on an aluminum cantilever for excellent tracking performance. Because the
AT-MONO3/LP does not easily pick up unnecessary strain components from
distorted or scratched records, it produces mono audio of a much higher quality
than that generated by a stereo cartridge. The cartridge features a strong,
rigid body of die-cast aluminum alloy and synthetic resin to eliminate
unnecessary vibrations. 

* This cartridge with 0.6 mil conical stylus is not compatible
with SP (standard play) shellac records. It is designed to play mono
microgroove 33-1/3 vinyl records.

  • Dual
    moving coil cartridge designed specifically for use with mono vinyl
    records*
  • Aluminum
    cantilever with 0.6 mil conical stylus
  • Strong,
    rigid body construction of die-cast aluminum alloy and synthetic resin
  • PCOCC
    (Pure Copper by Ohno Continuous Casting) coil enables pure signal transfer
  • Compatible
    with stereo playback systems

Frequency Response

20-20,000 Hz

Vertical Tracking Angle

23°

Vertical Tracking Force

1.5-2.5 g (2.0 g standard)

Recommended Load Impedance

400-47,000 ohms*

Coil Impedance

40 ohms (1 kHz)

DC Resistance

40 ohms

Coil Inductance

190 µH (1 kHz)

Output

1.2 mV (at 1 kHz, 5 cm/sec)

Stylus Shape

0.6 mil conical

Stylus Type

Bonded round shank

Cantilever

Aluminum pipe

Static Compliance

20 x 10-6 cm/dyne

Dynamic Compliance

7 x 10-6 cm/dyne (100 Hz)

Mount

Half-inch

Weight

6.8 g (0.24 oz)

Dimensions

16.0 mm (0.63″) H × 16.6 mm (0.65″) W × 26.5 mm
(1.04″) D

Accessories Included

Non-magnetic screwdriver; 2 washers; 2 nuts; cartridge
installation screws (13 mm × 2, 20 mm × 2); plastic protector; brush; PCOCC
lead wire set

Note: Stylus assembly is not
field-replaceable. 

* When connected to the MC input of a
transformer-less phono pre-amp, choose a lower gain position due to the high
output voltage (1.2 mV).

Additional information

Weight 0.00000000 lbs

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.