Audio-Technica AT-MONO3/LP High-Output MC Cartridge for Mono LPs & 45s

The AT-MONO3/LP is a high-output (1.2 mV) moving coil cartridge designed specifically for use with mono vinyl records.* Due to the horizontal configuration of its PCOCC (Pure Copper by Ohno Continuous Casting) voice coils, the AT-MONO3/LP cartridge only generates electrical signal with horizontal movement, yet it also has appropriate compliance in the vertical direction, making it safe for use with stereo records. The voice coils are wired in series, resulting in one mono signal that is transmitted to the cartridge’s white-blue terminals and red-green terminals in order to feed both inputs of a stereo phono preamp. 

The cartridge’s low-mass 0.6 mil conical stylus is mounted on an aluminum cantilever for excellent tracking performance. Because the AT-MONO3/LP does not easily pick up unnecessary strain components from distorted or scratched records, it produces mono audio of a much higher quality than that generated by a stereo cartridge. The cartridge features a strong, rigid body of die-cast aluminum alloy and synthetic resin to eliminate unnecessary vibrations. 

* This cartridge with 0.6 mil conical stylus is not compatible with SP (standard play) shellac records. It is designed to play mono microgroove 33-1/3 vinyl records.

• Dual moving coil cartridge designed specifically for use with mono vinyl records*

• Aluminum cantilever with 0.6 mil conical stylus

• Strong, rigid body construction of die-cast aluminum alloy and synthetic resin

• PCOCC (Pure Copper by Ohno Continuous Casting) coil enables pure signal transfer

• Compatible with stereo playback systems

Frequency Response	20-20,000 Hz
Vertical Tracking Angle	23°
Vertical Tracking Force	1.5-2.5 g (2.0 g standard)
Recommended Load Impedance	400-47,000 ohms*
Coil Impedance	40 ohms (1 kHz)
DC Resistance	40 ohms
Coil Inductance	190 µH (1 kHz)
Output	1.2 mV (at 1 kHz, 5 cm/sec)
Stylus Shape	0.6 mil conical
Stylus Type	Bonded round shank
Cantilever	Aluminum pipe
Static Compliance	20 x 10-6 cm/dyne
Dynamic Compliance	7 x 10-6 cm/dyne (100 Hz)
Mount	Half-inch
Weight	6.8 g (0.24 oz)
Dimensions	16.0 mm (0.63") H × 16.6 mm (0.65") W × 26.5 mm (1.04") D
Accessories Included	Non-magnetic screwdriver; 2 washers; 2 nuts; cartridge installation screws (13 mm × 2, 20 mm × 2); plastic protector; brush; PCOCC lead wire set

Note: Stylus assembly is not field-replaceable. 

* When connected to the MC input of a transformer-less phono pre-amp, choose a lower gain position due to the high output voltage (1.2 mV).