Pure & Simple Digital to Analog conversion with
Volume control
What more can you do after launching one of the best DACs
available today? The idea of having a decent volume control to prevent an
analog Pre-Amplifier could improve performance dramatically. However, we also
know that the way of introducing such device in the signal chain can also have
a negative effect. Experiments were made and as result the best sound was
coming directly from our new fully balanced DAC modules. Especially in
case of R2R ladder DACs it is quite easy to change the output voltage of the
DAC by changing its reference voltage. The SDA-2, a new generation DAC module
was designed to get the best regulation possible. The result of this process is
an extremely high linearity, right down to -140 dB, which gives our products a
realistic 24-bit dynamic range. It is musical, honors the
Non-oversampling principle and simultaneously incorporating the technological
progress that has been made over the years.
Digital to Analog Conversion with lossless volume control.
The Sonnet range will give you more weight, body, tonal richness, and a more
natural sense of the space of the recording. Or to put it more plainly, it
fleshes out your music more! This new range does a wonderful job of presenting
even the most complex music in a natural and inviting manner with every last
ounce of nuance intact. There’s no artificial sounding edge, no sense of a flat
cutout image, basically none of digital’s nastier stuff. In some cases, this
can also come with a somewhat dark and muddy sound but that is absolutely not
the case with the new Sonnet range. It allows you to hear deep into the
recording and the recording’s quality. This is somewhat of a good news/bad news
proposition in that you’ll really hear what’s there.
Morpheus preliminary data
Balanced Non oversampling DAC
Two SDA-2 DAC modules per channel in differential mode
Power supply 15VA 110/115V AC 220/230V AC 60/50Hz. Power required max 8
Watts
Input 1x optical, 1x coaxial and 1x AES/EBU and USB
Output 1x stereo pair single ended 2 Volts RMS
Output 1x stereo pair XLR balanced 4 Volts RMS
Frequency Response 44.1 kHz sampling 1Hz – 20 khz -2.5 dB
Frequency Response 192 kHz sampling 1Hz – 65 kHz – 3dB and 384kHz (USB)
Distortion 0.004% THD
Noise Floor -155 dB related to 2 Volt RMS
Output impedance RCA 100 Ohm, XLR 100 Ohm
Sampling rate Optical 44.1 – 96 kHz
Sampling rate Coax and AES/EBU: 44.1 -192 kHz
Sampling rate USB 44.1 – 384kHz
Aluminum six button remote control included.
MQA available as an option.
I2S option can be installed instead of the USB module
Dimensions 290 x 250 x 60 mm
Weight 3.2KG